How To Deal With The Drainage Problem Of Washing Machine?

Washing machine cannot drain water

Check: check whether the drain pipe is down, if down, then down; Check whether the end of the drain pipe is immersed in water and removed from water; Check that the end of the drain pipe is sealed in the sewer and removed from the sewer.

Otherwise: check whether the rubber seal of the drain valve seat is blocked by large or accumulated dirt; Check whether the drain pipe is 15cm above the ground; This means that the extended drain pipe is too long or too thin in diameter.

Washing machine drains slowly

Inspection: check whether the drain valve is blocked by accumulated debris; Check whether the drain pipe is bent and causes drainage blockage; If so, remove the accumulated material from the drain valve or replace the drain hose.

If not: check whether the clearance between drain rod and rubber valve is too large, and adjust the clearance between drain rod and rubber valve appropriately; Check whether the spring in the drain valve is too long or not elastic, then the internal spring needs to be replaced; If there are no other problems, the resistance drain solenoid valve movement core is too large or reduced suction.

The washing machine doesn't drain well

Check: check whether the performance of the water pressure switch in the air collecting chamber is poor, or air leakage in the air duct, so that the air pressure in the air collecting chamber becomes smaller, leading to the water level in the bucket does not reach the specified position, the water pressure switch contacts move ahead of time, resulting in the total drainage time, and finally the drainage is not clean phenomenon.

In this case, if the hydraulic switch is damaged, the hydraulic switch should be replaced in time; If the air line leaks, seal the leak with only 401 glue.